SPN 1072 - FMI 4 (Fault Code 2183)

SPN1072 FMI4 (Fault Code 2183)

Engine Brake Actuator Circuit 1 - Voltage Below Normal or Shorted to Low Source

ISL with CM2150 - Engine Brake Circuit

CODES:

Fault Code: 2183

PID(P), SID(S): S79

SPN: 1072

FMI: 4

Lamp: Amber

REASON: 

Engine Brake Actuator Circuit #1 - Voltage Below Normal or Shorted to Low Source. Low voltage

detected at the engine brake solenoid number 1 signal circuit.

EFFECT: Engine brake on cylinders 1,2, and 3 can not be activated.

Circuit Description:

This circuit can be used to control either an exhaust brake or an engine brake depending on the application. The electronic control module (ECM) controls engine brakes on cylinders 1, 2, and 3 by sending a signal on the engine brake solenoid number 1 signal circuit. If an engine brake is installed, there will be a jumper harness from this connector to the engine brake pass-through connectors on the rocker lever housing.

Component Location:

The engine brake solenoids are located under the valve cover. The engine brake solenoids are controlled through the engine harness from the ECM.

Conditions for Running the Diagnostics:

This diagnostic runs when the keyswitch is in the ON position and when the pulse width modulated device is getting energized or de-energized. In some cases the diagnostics can also run at some fixed intervals.

Conditions for Setting the Fault Codes:

The engine brake 1 circuit pulse width modulated signal is not detected to be system voltage when the pulse width modulated signal is turned on.

Action Taken When the Fault Code is Active:

• The ECM illuminates the amber CHECK ENGINE light immediately when the diagnostic runs and fails.

• The engine brake 1 circuit will be disabled.

Conditions for Clearing the Fault Code:

The ECM will turn off the amber CHECK ENGINE light and the fault code state will become inactive immediately after the diagnostic runs and passes. The fault code can also be cleared with INSITE™ electronic service tool.

Shop Talk:

Verify the electronic control module (ECM) calibration is correct. Check the calibration revision history found on QuickServe® Online for applicable fixes to the calibration stored in the ECM.

Possible causes of this fault code include a short circuit to ground in the engine harness, connector, or engine brake solenoids.

Read More:

SPN 1072 - FMI 3 (Fault Code 2182)

SPN 3064 - FMI 11 (Fault Code 1993)

Blog.Teknisi

Subscribe to receive free email updates: