SPN 1075 - FMI 3 (Fault Code 2265)
SPN1075 FMI3
Electric Lift Pump for Engine Fuel Supply Circuit - Voltage Above Normal or Shorted to High Source
 |
| ISC and ISL with CM2150 - Electric Fuel Lift Pump Circuit |
CODES:
Fault Code: 2265
PID(P), SID(S): S126
SPN: 1075
FMI: 3
Lamp: Amber
REASON: Electric Lift Pump for Engine Fuel Supply Circuit - Voltage Above Normal or Shorted to High Source. High voltage or open detected at the fuel lift pump signal circuit.
EFFECT: Engine can be difficult to start.
Circuit Description:
The circuit is a pulse width modulated driver in the electronic control module (ECM) that controls the electric fuel lift pump. The lift pump is grounded in the ECM.
Component Location:
The electric fuel lift pump is located behind the ECM cooling plate on the intake side of the engine.
Conditions for Running the Diagnostics:
This diagnostic runs when the keyswitch is in the ON position.
Conditions for Setting the Fault Codes:
The engine fuel lift pump circuit pulse width modulated signal is detected to be greater than 0-VDC when the pulse width modulated signal is turned off by the ECM.
Action Taken When the Fault Code is Active:
• The ECM illuminates the amber CHECK ENGINE light immediately when the diagnostic runs and fails.
• The engine fuel lift pump will be disabled.
Conditions for Clearing the Fault Code:
The ECM will turn off the amber CHECK ENGINE light and the fault code state will become inactive immediately after the diagnostic runs and passes. The fault code can also be cleared with INSITE™ electronic service tool.
Shop Talk:
Verify the electronic control module (ECM) calibration is correct. Check the calibration revision history found on QuickServe® Online for applicable fixes to the calibration stored in the ECM.
This fault becomes active if the ECM detects an open circuit at key-on. Causes of this fault code include an open circuit in the electric fuel lift pump circuit.
If the fault code is intermittent, look for causes of an intermittent open circuit, such as loose pins and bad connections. At key-on, the lift pump duty cycle ramps to 100 percent. This fault code can detect open circuit conditions only at keyon. The lift pump only runs at key-on and during cranking to aid in priming of the gear pump.
Read More:
Blog.Teknisi
0 Response to "SPN 1075 - FMI 3 (Fault Code 2265)"
Post a Comment