Cylinder Cutout Test on CUMMINS Engine using Cummins INSITE Software

Cylinder Cutout Test 

Figure 1.1 - Cylinder Cutout Test (Test Stop)

#Cylinder Cutout

To perform ECM Diagnostic Tests:

1). Open and connecting the CUMMINS Engine using Cummins INSITE. Read More: How to Connecting CUMMINS Engines using Cummins INSITE Software.

2). Click ECM Diagnostic Tests on the View bar. The ECM Diagnostic Tests Wizard window is displayed. The Wizard lists all tests available for the connected ECM. This list will vary depending on the connected ECM.

Figure 1.2 - ECM Diagnostic Tests Wizard

3). Select Cylinder Cutout Test from the list in the ECM Diagnostic Tests Wizard, then click Next, and the Cylinder Cutout Test window opens.

Figure 1.3 - Cylinder Cutout Test-1

4). Please note any messages or warnings in the Instructions box.
5). Click Start.

Figure 1.4 - Cylinder Cutout Test-2

6). Select which Cylinder to cutout by clicking it with your mouse.
7). Monitor the percent fuel and the RPM values while the Cylinder is disabled.

→When you select a Cylinder, then Cylinder number represents the Cylinder position number, not its firing order.

8). To re-enable all Cylinders after testing:

Figure 1.5 - Cylinder Cutout Test-3

→Click Restore All, or Stop to stop the test and restore all Cylinders (as Figure 1.1 Cylinder Cutout Test - Test Stop).


Read More:

Inquires Data Extraction on Cummins INSITE Software (CUMMINS Engines)

Air Intake Heater Control on Cummins INSITE Software (CUMMINS Engines)

Blog.Teknisi

Subscribe to receive free email updates: