Check the Starter Relay and ACC Cut Relay using TECHSTREAM (TIS) Software

Figure 1.1 - Activate the Starter Relay

Connecting MINI-VCI adapter to OBDII Diagnostic Port on your Car. Read More: Install MINI-VCI J2534 Driver untuk TECHSTREAM (Toyota TIS) Software.
Once connected, click "Engine and ECT" on "System Selection Menu".

Figure 1.2 - System Selection Menu

#Activate the Starter Relay

Click "Active Test" on the left-side menu, and "Active Test Selection" displayed as Figure 1.3 below. Choose "Activate the Starter Relay" from Active Test List display, then click "OK".

Figure 1.3 - Active Test Selection

-This test activates the Starter Relay.

-Command: ON/OFF.
-Operate with Ignition ON, Engine OFF, Shift Selector in P (AT) or Neutral (MT).

Figure 1.4 - Activate the Starter Relay (OFF)

Click on "<" to activate (ON) "Starter Relay". This function is same as Keyswitch when on START position. When status is ON (Starter Signal: ON), it will automatically cranking/ START (until engine is running), and then status will back again to OFF automatically as Figure 1.1 above.

Figure 1.5 - Activate the Starter Relay (ON)

#Activate the ACC Cut Relay

Close menu "Activate the Starter Relay" and back to "Active Test" menu. Choose "Activate the ACC Cut Relay", then click "OK".

Figure 2.1 - Active Test Selection

-This test activates the ACC Cut Relay.

-Command: ON/OFF

-Operate with Ignition ON, Engine OFF, Shift Selector in P.

Figure 2.2 - Activate the ACC Cut Relay (OFF)

Change monitoring "Data List" to "All Data" display, we need to monitoring the status of "ACC Relay". Click on "<" to activate (ON) "ACC Cut Relay", and check the power supply to ACC on Keyswitch will cut off and back again to normal operation, also the status will back to OFF again.

Figure 2.3 - Activate the ACC Cut Relay (ON)

Blog.Teknisi

Translate