TRAINER on Caterpillar ET Software

Trainer

Figure 1.1 - Status Tool (Trainer Active)

#Purpose:

Trainer runs the service tool in a training mode, which allows the user to become familiar with the service tool without connecting to an Electronic Control Module (ECM) or Communications Adapter. There is no charge for Trainer, and authorization is not required.

#To use Trainer:
1). Launch the service tool. The Connection message box is displayed.
2). Click the Stop Connect button. The service tool main screen is displayed.
3). Click the Enable Trainer icon on the toolbar, or select Trainer from the Help menu, and then select Enable from the sub-menu. The Trainer dialog box is displayed.

Figure 1.2 - Trainer (Enable)

4). Select a product from the Trainer dialog box.

Figure 1.3 - Select Trainer (1)

5). Click OK. The Connection message box is displayed. The ECM Summary screen is displayed in the trainer mode, and "Trainer Active" is displayed on the Title Bar. Trainer simulates some of the service tool functions.

Figure 1.4 - Connection

Figure 1.5 - ECM Summary (Trainer Active)

To change the product simulated within Trainer:
1). Select Trainer from the Help menu, and then select Properties from the sub-menu. The Trainer dialog box is displayed.

Figure 1.6 - Trainer (Properties)

2). Select a different product from the Application drop down list.
3). Click OK. The Connection message box is displayed, and then the ECM Summary screen for the new product is displayed.

Figure 1.7 - Select Trainer (2)

Product from the Trainer:
-3512B Genset
-C32 Marine
-627H Wheel Tractor Scrapper
-272C Skidsteer
-420E Backhoe
-D6T Track-Type Tractor
-C15 Truck EPA'07
-777G Off-Highway Truck
-336F HEX
-G3606 Gas Inline Engine
-C9.3 Engine
-980H Medium Wheel Loader
-140M Motor Grader
-324D Excavator
-G3516C EPG
-795F Off-Highway Truck
-C15 Genset with EMCP 3.3

Read More:

Low System Voltage on Caterpillar ET Software

Start/Run/Stop Switch on Caterpillar ET Software

Blog.Teknisi

Subscribe to receive free email updates: