Detroit Diesel Diagnostic Link (DDDL) Software: Injector Calibration
Injector (DDEC III, IV, and DDEC V only)
 |
| Figure 1.1 - Injector Calibration |
#To set new Calibrations for the Injectors (for example, after new Injectors
have been fitted):
1). Connect DETROIT Engine (60 Series) using Detroit Diesel Diagnostic Link (DDDL v6.50). Read More: How to Connecting DETROIT Engines using Detroit Diesel Diagnostic Link (DDDL).
2). Choose Injector from the Calibration menu to display
the Injector Calibration dialog box. The dialog box will show the current Injector Calibration values, as Figure 1.1 above (The Cylinders for the other blocks in multi-block Engines
will be shown below the master ECM block's Cylinders).
 |
| Figure 1.2 - Calibration (Injector) |
3). Enter the new Injector Calibration settings into the relevant
Cylinder # boxes.
4). To change your Injector password in the Injector Calibration dialog
box. Press Change Password to display the Change injector
password dialog box. Type your Injector password into the
Password box (you can change the password if required). Click OK.
 |
| Figure 1.3 - Change Injector Password |
 |
| Figure 1.4 - Change Injector Password (2) |
5). Press Print to print the data in the dialog box. The Print dialog box will be displayed so that you can choose how to
print the data. This dialog box is also displayed when you choose Print from the File
menu.
6). Press Transmit to send the new injector
calibration settings to the Engine (you must have entered a password first).
 |
| Figure 1.5 - Sending data to the ECM (Transmit) |
 |
| Figure 1.6 - Injector Calibration (2) |
7). Press Close to close the dialog box after making any required changes to the Injector Calibration.
8). In the Audit Trail, click on the Injector tab to see details of changes to the Injector Calibration.
 |
| Figure 1.7 - Audit Trail (Injector/ Last Change 4456) |
Read More:
Blog.Teknisi
Nice blog works well
ReplyDelete