Upload Calibration from the ECM using Detroit Diesel Calibration Tool (DDCT)

DDEC IV - Detroit Engine

Figure 1.1 - Calibration Manager (32.6)

#Open DDCT software (with the ECM connected).

→Comms - Upload Calibration

Figure 1.2 - Upload Calibration (Comms)

→Select ECU, then click OK.

Figure 1.3 - Select ECU (i.e Master - DDEC IV)

→If showing message: Unable to initialize programming mode. Turn ignition off and on again, then press Retry.

Figure 1.4 - Vector to Boot ROM

→DDEC IV Calibration Upload progress will be coming...

Figure 1.5 - Calibration Upload

→Dataset Constraints Scripting: Error Report (click OK).

Figure 1.6 - Error Report (OK)

→Upload Calibration successful (click OK).

Figure 1.7 - Calibration Tool (OK)

→ECM calibration will appear in left-hand panel, under the Calibration Manager.

Figure 1.8 - Calibration Manager (rel_32d.cal)

→Right click on the calibration file, then select Save Calibration As...

Figure 1.9 - Save Calibration As...

→Give it a File name, then click Save. The ECM calibration is safely on your hard drive.

Figure 2.1 - Calibration file (.cal)

Read More:

SPN 231 - FMI 12 (Fault Codes: J1939 Data Link Failure/ Code 55)

SPN 103 - FMI 8 (Fault Codes: Turbo Speed Sensor - Input Failure/ Code 64)

 

Blog.Teknisi

Subscribe to receive free email updates: